When I try to create a pattern for the Crux climbing pants, I get the error message “unable to draft part crux.back (set 0)”. My measurement set is complete. What am I doing wrong?
It could be that the pattern cannot be drafted because some measurements are out of range or mixed. Do a sanity check of your measurements, like:
are heights logically following one another
Waist to hips, Waist to seat, Waist,…., inseam
are
Waist back, Seat back similar and logically to the circumferences.
you can simply go to “Edit settings by hand” and check things.
here is one of my measurements sets that works:
waist: 840
hips: 900
inseam: 800
seat: 940
waistToKnee: 620
waistToHips: 100
waistToFloor: 1120
knee: 400
waistBack: 410
seatBack: 480
waistToSeat: 220
heel: 320
units: metri
1 Like
Thank you very much for pointing that out. I tried again with a newly created measurement set that contains only the measurements required for the Crux pants. I also entered the measurements manually, as shown in the image. Unfortunately, the same error message appeared both times.
The way you’re entering the data, I don’t see a save button at the bottom of the page:
By the way, I tried in a different browser (no success) and also with a curated measurement set (success).
Your waist to seat is smaller than your waist to hips. This is not possible. See I'm having trouble with measurements. What should I check? | FreeSewing especially the section about waist, hips and seat.
You seat measurement is also very wrong, it’s usually bigger than the hips measurement.
1 Like
Wow, good catch! I carefully remeasured the waist, hip, and seat measurements, and – ta-da! – everything works just as it should. Cool.
A big thank you to both of you!